It seems only a few work, like kbalance and d. I haven't found any others that work nor much good documentation for work commands I can use. Any help would be appreciated!

Hello! I am trying to run a Raspi and NyBoard together off of 2S-14500 batteries from EBL. The NyBoard runs pretty well by itself when I send commands over the serial monitor, however the problem arises when I have the raspi on top. Suddenly, it starts to do everything very slowly, stutters, or becomes completely unreceptive. This is a problem as I need to host a webserver and allow the Raspi to accept commands wirelessly and send the commands over serial to the NyBoard. Any suggestions for better batteries I should buy or other ideas? Thanks for reading!!!

Is the connector proprietary? Do I need to buy batteries directly from Petoi? If not, what connector is used and what would be a good battery I could buy? I have found a simple workaround but would like a more official solution to powering the NyBoard.

I have a RasPi 3B+ and some female header connectors. On the V1, I can see that the RasPi plugs its GPIO headers directly into the Nyboard. I assume this is how it's powered but I'm not sure.

I would like to make the robot faster/more advanced and that's what I heard would be available to me if I had a Pi in addition to a Nyboard. However I have not seen much documentation on how that relationship would work. Honestly, I'm not even sure what questions to ask at this point haha! Any insight is appreciated.