Could you send some pictures of your hardware set-up and a short video about this issue?

Usually there is no response leads to this exception. please make sure the switch on the bottom side of NyBoard is dialed to the Arduino side first. Then do the Upgrade Firmware.

Please try to use the latest version (V1.1.9) of Petoi Desktop App to Factory reset. If you still have problems, you can contact us by email (support@petoi.com); please attach a short video or screenshots with the uploading log. Thanks a lot.

Very nice!🏆

It's more clear!

Please refer to the doc in the Petoi Doc Center: https://docs.petoi.com/applications/skill-creation

There is a coding error. Please take a screenshot of the code you wrote. In the latest PetoiRobot.py: there is no code: list = str(list) So please re-import the extension library in the Mind+ app.

If you want him to go left or right and make that decision himself, please refer to the following one:

Please try to download and run the example code created by Dr. Li. It makes the robot avoid obstacles while moving forward.

Nice!❤️❤️❤️

Could you tell us how do you do this Bluetooth communication test more detailly? Thanks a lot.

I personally feel that how to select a servo mainly depends on the load that the robot has to bear.

What's the meaning of the cut vector code? Please try to give more information.

I think you modified the servo angle of the joint index 1(Pin 11 on the NyBoard) and 2(Pin 4 on the NyBoard), as following:

Could you share your solutions in a new post? Thanks a lot!

I have replied your email. Please check start-up melody to see if it's in the normal mode. For the startup melody in normal mode, please refer to the 00:14 in the video below: https://youtu.be/DrSsbd84ryo?t=14 If not, please re-upload the firmware via the Petoi Desktop App.

I'm curious to ask: What's the frame rate like? Approximately how many frames per second?

We just released the new version of the Petoi Desktop App (V1.1.9). Please Enjoy it. and re-import the Petoi Mind+ extension library in Mind+ to use the following block for RUS-04:

Yes, it is very simple.

Please send email to support@petoi.com to ask for the bootloader resetter.