Hi, it was a lot of fun putting the nybble together. I have everything up and running and the servos aren't working at all. I have the V1_0 board. I am wondering if the wiring is right. (Ground, + and -) The switch is set to Arduino. I did not see a way to do the calibration. I changed the * on#define NyBoard_V*_* in Instinct.h to match my NyBoard’s version. Then the three "Y" and then I save it. In the serial monitor, I type ‘c’ to enter calibration mode. Serial console: 16:12:09.035 -> 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16:12:09.035 -> 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 16:12:09.035 -> c0, 0, None of the servos move. I type ‘d’ to enter calibration mode. Serial console: nothing, but it makes a click sound. It was a smooth build/install up until now. Not sure what to do,,,,,,