petoi-camp-logo.png
Chinese
ZH
Chinese
ZH
English
EN
  • 主页

  • 论坛

  • Shop

  • 简介

  • 图鉴

  • 资源

    • Documentation Center
    • GitHub 源代码
    • 教程视频
    • NyBoard V0_1 手册
    • NyBoard V0_2 手册
    • Smartphone App
    • GitHub/CatMini
  • 社区

    • 成员
  • More

    Use tab to navigate through the menu items.
    Tomi Ade
    1 ngày trước

    Trouble Uploading to Nyboard - stk500_recv(): programmer is not responding

    3
    0
    Phillip Brush
    4 ngày trước

    On Definition Rule Issues

    4
    0
    Struzck
    2021年4月28日

    pyBittle, Open Source library to connect and control Bittle

    23
    5
    若要查看作用方式,請前往您的即時網站。
    • 類別
    • 所有文章
    • 我的文章
    Jordan
    2021年4月21日

    Bittle Setup in Arduino Studio

    在 Basic Assembly and Setup

    Hi I'm an experienced programmer, but an Arduino newbie and think I may be in a bit over my head. Do you have a detailed walkthrough of the Arduino setup process anywhere? The docs don't seem to indicate which ino file to open and when, if notes/warning messages are ok, which file to modify the baud rate in (assuming it's OpenCat.h), etc.. I know docs are not so easy to make, but if it wouldn't be too much trouble could you please make a video on this? Or perhaps there is a video or docs I am missing? Please advise and thank you!

    3 則答覆0 則回覆
    0
    3 則留言
    R
    Rongzhong Li
    2021年4月22日

    Hi, we have mentioned the settings of Arduino IDE mostly in the configuration chapter of Bittle.petoi.com. For example, it mentioned that the baudrate is configured in the serial monitor. However, if you want to learn Arduino systematically, you may check some Arduino tutorials.

    1
    J
    Jordan
    2021年4月25日
    回覆

    @Rongzhong Li it also says to modify the baud rate in the code. I found only one place it was set, but it was not specific - assuming I modified it in the right place though considering it doesn’t appear to be set anywhere else.

    按讚

    R
    Rongzhong Li
    2021年4月26日
    回覆

    @Jordan In our official demo, the baudrate is set as 115200 already. So you don't need to change the code.

    按讚
    3 則留言
    相似文章
    • No comms with bittle
    • Bittle crashing
    • I just recieved my Bittle Kit keep getting these error running arduino

    Pittsburgh, PA, USA | info@petoi.com 

    © 2019 Petoi LLC

    © 2019 Petoi LLC