Hey all, I'm new to the community and apologies for the basic question - I'm at the early stages of setting up Nybble and was going to calibrate the servos before installing to the body, but upon pressing 'c' to go into calibration mode, 5 of my servos are spinning like crazy even after 3 minutes so I pressed reset, why is this and how do I calibrate properly? This is what serial monitor is showing:
Servo:27.00SkillTaskQReady!gd0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, cTHANKS MUCH!!!
Dalam permainan slot terdapat istilah seperti RTP, scatter, wild, dan payline yang wajib dipahami. Semua fitur ini membantu menentukan peluang kemenangan. Platform Slot88 menyediakan berbagai panduan dan info lengkap untuk memudahkan pemain baru memahami mekanisme permainan slot modern.
I figured out what's wrong, I was buying my own parts and had the wrong servos (360 instead 180) - this is now fixed but now I encountered another problem, when calibrating the offsets (e.g. c0 5) the servos do not move, why is this? Thank you
Hi, could you send a video to support@petoi.com so we can better diagnose the problem?