Hi, when I run writeinstinct in the MPU calibration routine the program loops on showing the 6 numbers over and over and does not stop. I have close serial monitor to end it.
After calibration, you need to upload the OpenCat.ino as the functional code.
Thanks that worked, but no noise from Bittle
Yes thats correct and the board is stationary while calibating
The Z-axis is not used. Try to change the 6 to 5 to bypass the loop.
Have you put the Bittle （Nyboard） on the horizon surface and execute calibration program when running "WriteInstincts.ino" skectch?
The switch is set Arduino