Hello, I have a bittle x robot. I removed the old board (BiBoard) and installed the Nyboard and connected it to the servos and made sure of the connection. I downloaded the code and made sure to activate the type of board and the robot, but when I started it and gave it some commands with the remote, the servos did not work well. I calibrated the servos, some of them work and some do not, so I installed the old board to return it to work, but the servo became worse. acutally the servos when I bought the robot after a few months Sometimes it didn't work well. Is there a solution to the problem because it happened suddenly? Is the only solution to reassemble the robot from scratch or buy a new servos or are there other solutions?
top of page
bottom of page
Please double check the servo wiring for NyBoard: https://docs.petoi.com/petoi-robot-joint-index/joint-pins-on-nyboard/bittle
For how to debug the servo, please refer to: https://docs.petoi.com/faq-frequently-asked-questions#the-robot-servos-dont-seem-to-be-working.-how-to-debug-the-servos