Hello, I have a bittle x robot. I removed the old board (BiBoard) and installed the Nyboard and connected it to the servos and made sure of the connection. I downloaded the code and made sure to activate the type of board and the robot, but when I started it and gave it some commands with the remote, the servos did not work well. I calibrated the servos, some of them work and some do not, so I installed the old board to return it to work, but the servo became worse. acutally the servos when I bought the robot after a few months Sometimes it didn't work well. Is there a solution to the problem because it happened suddenly? Is the only solution to reassemble the robot from scratch or buy a new servos or are there other solutions?

Hi everyone, I have been doing some work on the project. I have removed the old board (BiBoard) and installed the new board (Nyboard) and the music and lights worked on the new board I expect that it is working now and I only have to upload the code, and as for the Raspberry I downloaded the system on it and I installed the Raspberry over the Nyboard using female headers and it worked and also I entered the Raspberry system using Windows Powershell but now I have a problem I want to install the camera and voice and AI chip on the Raspberry we can do it using the Raspberry GPIO But you know how the ports of these chips cannot be mounted on the Raspberry pins. If Anyone have advice, I would be grateful to you.

i have a graduation project. I bought a robot dog bittle x and I have to develop it using things I bought: petoi Voice Recognition, AI Vision, intelligent Camera, Nyboard, Petoi Sensor Pack and finally a raspberry pi3 model A. But I am a beginner. Can anyone help me with the steps🙏?