Does anyone have the Bittle 3D model for the MU vision sensor holder?

Question

As seen in red in the picture below. I'd love to 3D print it :D

Rongzhong Li · Accepted Answer

You can download the structure at https://github.com/PetoiCamp/NonCodeFiles/blob/master/stl/bone.stl

Sevaztian Soffia Otarola · Answer

I missed the concept of using the bone as a holder haha, very nifty. Thank you for the reply!

Brad S · Answer

I'm finding with Bittle's overbite the camera faces down a little too much (the top of the mouth is further out than the bottom). has anyone printed a modified bone that pushes the camera out at the bottom to tilt it up a little? or any other ideas?

Rongzhong Li · Answer

You can adjust the angle by dragging the rubber band while tilting the camera.