主页
论坛
Robot Shop
简介
图鉴
资源
社区
More
As seen in red in the picture below. I'd love to 3D print it :D
I'm finding with Bittle's overbite the camera faces down a little too much (the top of the mouth is further out than the bottom). has anyone printed a modified bone that pushes the camera out at the bottom to tilt it up a little? or any other ideas?
You can adjust the angle by dragging the rubber band while tilting the camera.
I'm finding with Bittle's overbite the camera faces down a little too much (the top of the mouth is further out than the bottom). has anyone printed a modified bone that pushes the camera out at the bottom to tilt it up a little? or any other ideas?