petoi-camp-logo.png
Chinese
ZH
Chinese
ZH
English
EN
  • 主页

  • 论坛

  • Shop

  • 简介

  • 图鉴

  • 资源

    • Documentation Center
    • GitHub 源代码
    • 教程视频
    • NyBoard V0_1 手册
    • NyBoard V0_2 手册
    • Smartphone App
    • GitHub/CatMini
  • 社区

    • 成员
  • More

    Use tab to navigate through the menu items.
    Tomi Ade
    1d

    Trouble Uploading to Nyboard - stk500_recv(): programmer is not responding

    3
    0
    Phillip Brush
    4d

    On Definition Rule Issues

    4
    0
    Struzck
    2021年4月28日

    pyBittle, Open Source library to connect and control Bittle

    23
    5
    若要查看作用方式,請前往您的即時網站。
    • 類別
    • 所有文章
    • 我的文章
    Alex
    2020年5月04日

    Connect old 2.4GHz RC transmitter

    在 Hardware

    Hi, I was seeing few videos on how to connect your old RC transmitter with the arduino. It seems possible but you need as well entire board from the RC Car that will decode the signal. I have both. The question is on how to connect it with Nybble board - if possible at all. It would be cool if it is possible to controll Nybble that way. I am willing to try and will be doing some research in the following days. Any hint/advise is appreciated.


    4 則留言
    0
    4 則留言
    Alex
    2020年5月06日

    Thanks for the reply, another thought, by following instructions for a bluetooth module, can you pair that module with PS3 or PS4 controller?


    按讚
    L
    Len
    2020年5月06日
    回覆

    The BT module also needs the secondary UART, I think 2.4G reciever for wireless PS2-like controller may a better choice.

    You can also choose the Nordic NRF24L01 as a reciever or transmitter (pairs) with SPI interface. Nybbleboard V0 has SPI interface. Becareful of the flash capacity!


    按讚

    L
    Len
    2020年5月06日

    Hi, do you mean RC model transmitter as Tamiya etc ?

    As the limitation of Flash / Frequency / UART Serial in ATMega328P, the opencat now cannot compatible with RC model transmitter officially.

    There's 6-8 PWM channels in a typical RC transmitter and it's difficult to set your RC transmitter for a "Cat like" Model. Use S-BUS or PPM signal is not supported by NybbleBoard V0 (only 1 UART Serial supported by chip).

    We will try to support RC BUS signal in next generation of NybbleBoard V1 that has another UART~

    My poor English LOL~

    按讚

    R
    Rongzhong Li
    2020年5月05日

    The most convenient way is to wire the serial port on NyBoard and communicate with string tokens:

    https://www.petoi.com/forum/hardware/add-bluetooth-module-for-uploading-sketches-and-communication

    https://docs.petoi.com/chapter4#4-3-arduino-ide-as-interface


    按讚
    4 則留言
    相似文章
    • FTDI Connection
    • Easier Connection to FTDI
    • Connect to computer

    Pittsburgh, PA, USA | info@petoi.com 

    © 2019 Petoi LLC

    © 2019 Petoi LLC