I am attempting to work out the placement of the Raspberry Pi3B+ over the Nyboard v0.2. I have the expansion connectors in place and connecting the Pi to the Nyboard and the mounting locking pin in place, but I see on the other side the the PI analogue 3.5mm AV connector and camera connector hit the Nyboard SW3 connector and does not allowing the PI to sit lower enough for the locking piece to go into place. (see photo)
Any advice on what is happening here or what I should do here?
Best regards
DL
Thanks. I put a piece of electrical tape on each board so there's a double-tape barrier where the pieces might touch. Thanks!