petoi-camp-logo.png
Chinese
ZH
Chinese
ZH
English
EN
  • 主页

  • 论坛

  • Shop

  • 简介

  • 图鉴

  • 资源

    • Documentation Center
    • GitHub 源代码
    • 教程视频
    • NyBoard V0_1 手册
    • NyBoard V0_2 手册
    • Smartphone App
    • GitHub/CatMini
  • 社区

    • 成员
  • More

    Use tab to navigate through the menu items.
    Hanna Ovr
    8月02日

    Pest Control Software

    2
    0
    Rafael Marín
    3d

    Error moving joints simultaneously in Mobile app

    5
    0
    Tomi Ade
    6d

    Trouble Uploading to Nyboard - stk500_recv(): programmer is not responding

    3
    0
    若要查看作用方式,請前往您的即時網站。
    • 類別
    • 所有文章
    • 我的文章
    Carlos Costa
    2021年3月25日
    已編輯: 2021年3月25日

    Can't get Petoi to work properly

    在 General Discussions

    I've now received my Petoi and it took about 1h to assemble and configure but unfortunately it's not working as expected. It either goes into calibration mode or is limited to one jerky movement (seems like it's trying to bark?)


    Here's my process: > Petoi hardware assembly > Downloaded required libraries for IDE (Adafruit PWM Servo Driver and IRremote 2.6.1 libs) > After fixing the irremote.h file I uploaded WriteInstinct.ino and YY's in the serial (there are only 2 Y requests btw, not 3). The MPU appeared to be configured properlly. > I then uploaded Opencat.ino and this was also successful with the long beep indicating there was no battery. > I then calibrated the Petoi legs using serial. After all calibration was successful, any command I send to Petoi via serial or via IR remote the Petoi only does one of two things: A) Successfully goes into Calibration mode (all 4 legs to reset position) B) Jerk movement like it's trying to bark, mount something or maybe has worms ...... The only commands that do work in the serial are something like this: m0 30 I looked around in the forum and in the documentation and there is nothing regarding this issue. Board is: NyBoard V1_0 Thanks in advance for any help!

    2 則答覆0 則回覆
    0
    2 則留言
    R
    Rongzhong Li
    2021年3月25日
    最佳解答

    have you set the serial monitor as no line ending and 115200 baud rate before sending "Y" with writeInstinct.ino?

    2
    C
    Carlos Costa
    2021年3月25日
    回覆

    I tried doing all the same process and noticed the no line ending was not set. Having set this Petoi seems to now be working! Thanks for the help :)

    按讚
    2 則留言
    相似文章
    • My petoi stopped working
    • I can't calibrate my cat properly
    • DOA Petoi?

    Pittsburgh, PA, USA | info@petoi.com 

    © 2019 Petoi LLC

    © 2019 Petoi LLC