Hello, I have a bittle x robot. I removed the old board (BiBoard) and installed the Nyboard and connected it to the servos and made sure of the connection. I downloaded the code and made sure to activate the type of board and the robot, but when I started it and gave it some commands with the remote, the servos did not work well. I calibrated the servos, some of them work and some do not, so I installed the old board to return it to work, but the servo became worse. acutally the servos when I bought the robot after a few months Sometimes it didn't work well. Is there a solution to the problem because it happened suddenly? Is the only solution to reassemble the robot from scratch or buy a new servos or are there other solutions?
top of page

bottom of page
It should not matter from a servo perspective, but what was the reason you swapped out the BiBoard that came with the Bittle X robot and put in a NyBoard (normally found in the Bittle Stem Kit)? For some purposes, the BiBoard is the right choice (See here).
As to the servo problem, a video showing the behavior of each servo (say starting from the "Stand" position, using the Skill Composer applet in the Petoi Desktop App) would be helpful to understand what you are seeing.